1
Press the [DUST] button, turning it on.
2
Set the following parameters.
Knob
1
2
3
4
a) The way in which the afterimage disappears is affected by both the Video Decay and
Decay Dust parameter adjustments for the motion decay.
Keyframe Strobe Settings
Each time a keyframe is passed, the video image is frozen, and left remaining.
Note
When you turn on keyframe strobe, if the Trail, Motion Decay or Wind effect
is on, it automatically goes off.
Leaving a trail of afterimages of the image
1
In the DME menu, select VF5 'Light/Trail' and HF4 'KF Strobe.'
The KF Strobe menu appears.
2
Press [KF Strobe], turning it on.
This enables the Keyframe Strobe effect, and you can now use the knobs
to adjust the parameters.
3
Set the following parameter.
Knob
1
a) At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not
decay.
4
To erase the afterimage, press [KF Strobe Eraser], turning it on.
Parameter
Adjustment
Decay Dust
Amount of the afterimage
disappearing as stardust
Dust Soft
Timing with which stardust
disappears
Dust Size
Size of stardust
Dust Aspect
Aspect ratio of stardust
Parameter
Adjustment
Decay
Degree of blurring of the video
signal
Setting values
0.00 to 100.00
a)
0.00 to 100.00
0.00 to 100.00
–100.00 to +100.00
Setting values
0.00 to 100.00
DME Special Effect Operations
a)
121