Settings Relating To Video Switching (Transition Menu) - Sony MVS-8000 User Manual

3
4
5

Settings Relating to Video Switching (Transition Menu)

For settings relating to video switching, use the Switcher >Transition menu.
To display the Transition menu
In the Engineering Setup menu, select VF3 'Switcher' and HF4 'Transition.'
The status area shows the transition preview, key transition, bus toggle, and
split fader settings for each M/E and P/P bank.
Selecting the bank to which the settings apply
In the Transition menu, using any of the following methods, select the bank to
which the settings apply, then make the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
The selected bank appears in reverse video.
Setting the transition preview mode
To select the transition preview mode, in the <Transition Preview> group of
the Transition menu, select either of the following.
One Time: The transition preview ends after a single transition.
404
Setup Relating to Switcher Processor
Out 15-16: The outputs from the format converter output connectors
(FC1, FC2) are fixed, being the same signals as from Out 15 and Out
16.
Out 17-22: Assign the signals selected from the list on the right.
In the box on the left, press [1] or [2] to select FC Output 1 or 2.
In the box on the right, select the output signal.
Press [Set].
This assigns the signal.
Note
It is not possible to assign the same signal to the format converter outputs
1 and 2.
Parameter Adjustment
Bank M/E or P/P selection to which settings apply
Setting values
1 to 4