Sony MVS-8000 User Manual page 515

With ccp-8000 series center control panel

Hide thumbs Also See for MVS-8000:

Table of Contents

• During macro editing, if you press any of the mode selection buttons in the

• While carrying out macro editing in the Flexi Pad control block, pressing a

Macro Operations in the Simple Type Flexi Pad Control Block

As an example, when register 1 is specified, the memory recall section

buttons appear as in the following figure.

Carry out the control panel operation to be registered as an event in the

For details of the events that can be registered, see "Overview" under

"Macros" in Chapter 1 (Volume 1).

In the Flexi Pad control block, it is not possible to set a pause event. To set

a pause event, use the numeric keypad control block.

Press the [INS] button.

This registers the operation carried out in step 3 as an event within the

Repeat steps 3 and 4 to register the required events in the macro.

The numeric display shows the last registered event position, and the total

number of events.

Press the [STOR 1] button in the memory recall section.

This saves the created macro in the register and ends the macro editing

mode; the [MCRO] button lights amber.

Flexi Pad control block other than [MCRO] button (the [WIPE] button,

[DME] button, and so on), the executed operation is also registered as an

event. In this case, the [MCRO] button stays lit red.

button to which a macro attachment is set does not execute the macro.

"1" is register number

Show Quick Links

Table of Contents