Spotlighting Settings - Sony MVS-8000 User Manual

Spotlighting Settings

Creates the effect of a spotlight striking the surface of the image.
For a sample illustration and other information, see "Digital Multi Effects
(DME)" in Chapter 1 (Volume 1).
Notes
• The Spotlighting effect is not supported on the MVE-8000/8000A.
• When the global effect Combiner is enabled, the settings of the smallest-
Setting the surface where light strikes the image
1
2
3
4
126
DME Special Effect Operations
numbered channel selected for the Combiner are used.
In the DME menu, select VF5 'Light/Trail
The Spot Lighting menu appears.
Press [Spot Lighting], turning it on.
This enables Spotlighting, and you can now use the knobs to adjust the
parameters.
Set the following parameter.
Knob Parameter
1 Total Ambient Brightness of whole image
• Lowering the brightness of the image makes Spotlighting more
effective.
• The Total Ambient setting is shared with the Lighting function.
In the <Surface Select> group, select the state of the surface struck by the
light.
Flat: The image surface is unchanged, causing the selected light source to
appear as the effect.
Texture: A texture appears on the surface of the image.
Non Linear: The Spotlighting effect is applied to an area to which a DME
nonlinear effect is applied.
Notes
• The BZDM-9050 Texture Lighting Software (for MVE-9000) is
required to enable Texture or Non Linear.
An install key must be entered to use the software (see page 301).
'
and HF6 'Spot Lighting
Adjustment
.'
Setting values
0.00 to 100.00