Sony MVS-8000 User Manual page 303

BZDM-8560
a) This can be used only with a CCP-8000 series control panel equipped with the MKS-8010A.
b) This can be used only on the MVS-8000G.
c) This can be used only on the MVS-8000GFS.
d) This can be used only on the MVS-8000G/GFS.
e) This can be used only on the MVE-8000A.
To use the software listed above, you are required to enter an install key which
validates the software. (If the software has been factory installed, the install key
is not required.)
For the method of obtaining an install key, contact your Sony representative.
To obtain a key, you may be required to submit the unique device ID of the
switcher you are using. You can check the unique device ID in the Install/Unit
Config menu of the switcher, using the following procedure.
To display the unique device ID
1
2
302
Setup for the Whole System
DME Upgrade Software
In the System >Install/Unit Config menu, use either of the following
methods to select the device for which you want to register the license.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
Press [License].
The License menu appears as follows.
e)