Sony MVS-8000 User Manual page 293

3
Enabling the FM data port of the switcher
With the FM data port enabled, frame memory data can be transferred in a short
time between the switcher and the control panels.
Notes
• If multiple control panels are in use, [FM Data Port Enable] can be turned on
• This function is not available on the MVS-8000.
1
2
3
Setup in "Dual Simul" mode
When the system operation mode (see page 290) is set to "Dual Simul," the
following setting is required for setup of the two switchers and connected DME
units.
In the <Setup Target> group, set the [System 1] or [System 2] button to On,
then carry out the setup. You can also set both to On, and make the settings
simultaneously on the two systems.
292
Setup for the Whole System
The selected switcher appears in reverse video.
If there is only one switcher on the network, carry out the SWR1 setting
(for the first switcher) only.
Make the DME settings as follows.
• When making DME settings for SWR1 (the first switcher), for the
first DME, select [DME1] in the <1st DME> group. For the second
DME, select [DME2] in the <2nd DME> group. When a second DME is
not connected, turn all buttons in the <2nd DME> group off.
• When making DME settings for SWR2 (the second switcher), for the
first DME, select [DME3] in the <1st DME> group. For the second
DME, select [DME4] in the <2nd DME> group. When a second DME is
not connected, turn all buttons in the <2nd DME> group off.
for only one control panel per switcher.
In the System >System Config menu, press [Switcher Assign].
The Switcher Assign menu appears.
Using any of the following methods, select the switcher to be set.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
The selected switcher is displayed in reverse video.
If there is only one switcher on the network, make the setting only for
SWR1 (the first switcher).
Press [FM Data Port Enable], turning it on.