Sony MVS-8000 User Manual page 531

Background A row
If you make both pre macro and post macro settings for the same
button
The later setting is valid.
To set a macro attachment without changing cross-points
When you set a macro attachment to a cross-point button, you can make the
setting without changing the bus cross-points. Carry out this selection in the
Engineering Setup >Panel >Operation menu. For details, see "Setting the
macro execution mode" (page 380).
To make a macro attachment setting in macro only mode
Note
To carry out this operation, it is first necessary to assign the "Macro Only Set"
function to the user preference buttons in the menu control block or the utility/
shotbox control operation. Carry out this assignment in the Eng Setup >Panel
>Prefs/Utility menu. (For details, see "Setting Button Assignments (Prefs/
Utility Menu)" (page 356).)
To make a macro attachment in macro only mode, use the following procedure.
530
Macro Attachment Assigning
Background B row
The cross-point button you pressed flashes amber, and the register you
recalled in step 1 is assigned to the button.
PRE MCRO button
M/E M/E M/E XPT
SHIFT
1 2 3 HOLD
M/E M/E M/E XPT
SHIFT
1 2 3 HOLD
PRE
SHIFT
MCRO
M/E M/E M/E
XPT
SHIFT
1 2 3 HOLD
M/E M/E M/E
XPT
SHIFT
1 2 3 HOLD
MCRO ATTCH ENBL button
POST MCRO button
KEY3
KEY4
POST
MCRO
MCRO
ATTCH
ENBL
UTIL