Wind Settings - Sony MVS-8000 User Manual

Knob
2
3
4
a) The way in which the afterimage disappears is affected by both the Decay and KF Strobe
Dust parameter adjustments for the keyframe strobe.
Disabling the keyframe strobe afterimage
Press [KF Strobe Disable], turning it on.
If you turn this function on when creating a keyframe, even as the effect passes
a keyframe, no afterimage remains.
Setting a combine process
Select whether to add the Keyframe Strobe effect before or after the combine.
Notes
• The combine process function is not supported on the MVE-8000/8000A.
• When you change the selection in the <Combine Process> group, the
afterimages which had been added up to then disappear.
• When you do not combine images, the Keyframe Strobe effect only is
applied, regardless of the selection in the <Combine Process> group.
Select one of the following in the <Combine Process> group.
Combine –> KF STRB: Add the Keyframe Strobe effect after the combine.
As parameters, the data for the channel with the lowest number among the
channels being combined is enabled.
KF STRB –> Combine: Add the Keyframe Strobe effect before the combine.
Parameters can be set independently for each channel.

Wind Settings

This effect strobes the image at regular intervals, and moves the frozen image
in a fixed direction, leaving an afterimage.
For example images, "DME Special Effects" in Chapter 1 (Volume 1).
Notes
• The wind function is not supported on the MVE-8000/8000A.
• When wind is turned on, any of the following effects that are on are turned
off.
Parameter Adjustment
Dust Soft Timing with which stardust
disappears
Dust Size Size of stardust
Dust Aspect Aspect ratio of stardust
Setting values
0.00 to 100.00
0.00 to 100.00
–100.00 to +100.00
DME Special Effect Operations
123