Sony MVS-8000 User Manual page 510

or [DME] button) to record the executed operation as an event. In this case,
the [MCRO] button remains lit red.
• During macro editing, if you press a button for which a macro attachment is
set, the macro within the register assigned to the button is merged into the
macro being edited. However, the macro assigned to the button is not
executed.
• While carrying out macro editing in the Flexi Pad control block, absolutely
no macro operations are possible in the Flexi Pad control blocks for other M/
E and PGM/PST banks. Macro operations from the numeric keypad control
block are also not possible.
To cancel the saving of a macro
To cancel the saving of a macro immediately after performing it, hold down the
[STORE STATS] button and press the [UNDO] button.
Inserting a pause event
1
Press the [PAUS] button in the memory recall section.
The buttons in the memory recall section change as follows.
2
Enter the length of pause you want to set (0 to 999 frames).
3
Press the [PAUS ENTR] button.
This sets the pause length, and inserts the pause event.
The memory recall section display returns to its former state.
Deleting a macro
1
In the Flexi Pad control block, press the [MCRO] button.
This assigns the Flexi Pad control block to macro operations.
The numeric display shows the previously selected bank number and the
number of the last recalled register.
7 8 9
4 5 6
1 2 3
0 PAUS
CLR
ENTR
Macro Operations in the Standard Type Flexi Pad Control Block
509