Sony MVS-8000 User Manual page 438

b) When knob 2 selection is "Key Snapshot"
c) When knob 2 selection is "Snapshot"
d) When knob 2 selection is "Effect"
e) When knob 2 selection is "Aux ? O'ride Src ??"
5
To confirm the setting in step 4, press [Action Set].
This confirms the setting, which appears in the status area.
Carrying out level settings
To set the low level and high level, first set the trigger type to "Level," then use
the following procedure.
1
In the DCU >GPI Input Assign menu, select the action to be set, and press
[H/L Set].
The H/L Set menu appears.
2
Using any of the following methods, select the settings.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
3
To apply the selection made in step 2 when the input is the GPI high level,
press [H Set]. To apply the selection made in step 2 when the input is low,
press [L Set].
This confirms the setting, which appears in the status area.
the power may go off before the action is completed. This may corrupt the setup
settings. It is therefore recommended to use Level Enable to avoid such a situation.
• As for "Aux ? O'ride Src ??," when "Rising Edge" is selected, on a rising edge the
set AUX bus primary input is used. On a falling edge, the original state of the cross-
point is restored. If the GPI trigger is applied repeatedly at short intervals (0.5
second or less), the cross-point switching may not be carried out correctly. In this
case, apply the GPI trigger again.
• If "SWR Format" or "System Format" is selected for "Action" when the format
converter is used on the MVS-8000G, you can set the conversion formats of the
format converter for "FC Input 1-8" and "FC Input 9-16".
Parameter Adjustment
No Signal format/screen aspect ratio
selection
Setting values
1 and upwards
437
Setup Relating to DCU