Installing The Menu Panel; Installation Of Options - Sony MKS-9011A Installation Manual

1-5. Installing the Menu Panel

The menu panel MKS-8011A can be installed to the
monitor arm compliant with VESA Standard using the
adapter supplied with CCP-9000A-C. See the dimensions
for installation below.
Adapter installation dimensions (compliant with
VESA Standard)
75 mm
4-M4
The following parts supplied with CCP-9000A-C are
required to install the menu panel.
n
Use the specified accessories when installing the menu
panel.
. Adapter
. 50-pin cable
. Screws B3 x 5 (4)
. Screws B4 x 8 (4)
Installation
n
Connect the 50-pin cable attached to the menu panel, and
then perform the following steps.
1. Install the adapter to the menu panel with the attached
four screws (B3 x 5).
Adapter
B3 x 5
1-10
100 mm 4-M4
B3 x 5
50-pin cable
Menu panel
2. Install a commercially available monitor arm to the
adapter with the attached four screws (B4 x 8).
n
For installation of monitor arm, refer to its operation
manual.
100 mm
75 mm
Adapter
75 mm
100 mm

1-6. Installation of Options

The CCP-9000A-C system is comprised of the following
models according to the system to be used, and shipped
from the factory.
Model name
MKS-9011A 1 M/E CONTROL PANEL
MKS-9012A 2 M/E CONTROL PANEL
HK-PSU11 POWER SUPPLY UNIT
MKS-8011A MENU PANEL
MKS-8031ATB TRACK BALL MODULE
MKS-8032A DSK FADER MODULE
MKS-8033A UTILITY/SHOTBOX MODULE
MKS-8035A KEY CONTROL MODULE
MKS-8041 BLANK PANEL (1/2)
MKS-8075A EXTENSION ADAPTOR
SWC-5002 PANEL CABLE (2 m)
SWC-5005 PANEL CABLE (5 m)
SWC-5010 PANEL CABLE (10 m)
B4 x 8
B4 x 8
Monitor arm
CCP-9000A