Sony MVS-8000 User Manual page 374

• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob
1
a) The range of the setting value depends on the DCU port settings.
The DCU number, slot number, and serial port number appear.
3
Select the device selection button to be assigned from the <Assign> group.
Notes
• It is not possible to assign more than one device selection button to the
same port. The later assigned device selection button takes priority, and
the previous selection is invalidated.
• If P-Bus/Mixer ESAM-II is assigned to a serial port, it is not possible to
assign a device selection button to that port.
4
Repeat steps 2 and 3 as required to make assignments to other ports.
To select whether to use an editing keyboard
If you want to use an editing keyboard for the selected device, select a port
using the same operation as in step 2, then press [Plug-In Editor Enbl] to
display "Enbl" in the Editor column. If you do not want to use an editing
keyboard, press [Plug-In Editor Enbl] to make the "Enbl" display disappear.
Notes
• This selection is possible when the BZS-8050 license is valid (see page 301).
• A port to which Mixer ESAM-II is assigned is automatically set to Enbl, and
you cannot change this setting.
Sharing disk recorder/Extended VTR file lists
To share files between devices connected to the same disk recorder/Extended
VTR, use the following procedure.
Note
The following operation can only be carried out for the ports to which a disk
recorder or Extended VTR is assigned.
1
In the Panel >Device Interface >Serial Port Assign menu, select the target
disk recorder/Extended VTR.
• Press directly on the list in the status area.
Parameter Adjustment
No Serial port selection
Setup Relating to Operations From the Control Panel
Setting values
a)
1 and upwards
373