Batch Copying Files - Sony MVS-8000 User Manual

Batch Copying Files

To copy files between the hard disk and a memory card, use the following
procedure.
1
In the operating device selection section to the left of the All menu, select
the storage location ([HDD] or [Memory Card] and directory) of the
source files (see page 468).
2
In the operating device selection section to the right of the All menu, select
the destination storage location ([HDD] or [Memory Card] and directory)
(see page 468).
3
If there are files you do not want to copy, remove them from the selection
in the <Category> group. To select all files, press [All Select].
For details of the data to which the operation applies, see "Files" in
Chapter 1 (Volume 1).
Note
The frame memory is not selected when you press [All Select]. To apply
the setting to frame memory, press [Frame Memory], turning it on. When
frame memory is selected, it is not possible to apply settings to the
<Category> group data.
4
Press [t Copy].
This copies the selected files to the specified destination.
If there is already data present in the destination location, a confirmation
message appears.
• Select "Yes" to overwrite.
• Select "No" to cancel copying all of the files.
481
File Batch Operations