Sony MVS-8000 User Manual page 424

Knob
1
a) 0: EDIT PVW
1 to 48: AUX1 to AUX48
4
Select whether to enable or disable AUX bus control from the <Control
Mode> group.
Enable: enable control of the port selected in step 2.
Disable: disable control of the port selected in step 2.
Manual: make whether control of the port selected in step 2 is possible or
not depend on the setting in the Misc menu.
5
Repeat steps 2 to 4 as required to make the settings for other ports.
Setting the interface between the DME and the switcher
To set the interface between the DME and the switcher when the DME is an
MVE-8000A or MVE-9000, proceed as follows.
1
In the Switcher >Device Interface menu, press [DME Type Setting].
The DME Type Setting menu appears.
2
In the <DME1 Type> group to set DME1 or in the <DME2 Type> group
to set DME2, press either of the following, turning it on.
Dedicated: The MVE-8000A/MVE-9000 has an MVS-8000-series
dedicated interface.
SDI: The MVE-8000A/MVE-9000 has an SDI interface.
3
To select the number of keys that use DME on an M/E bank, make one of
the following selections in the <DME Assigned Key per M/E> group.
Up to 2 Keys: Mode in which a processed key operation is carried out only
with the dedicated interface DME or the SDI interface DME.
Up to 3 Keys: Mode in which two processed key operations with the
dedicated interface DME and the SDI interface DME are both possible
simultaneously on the same M/E. When this mode is selected, when
combined by a processed key with the SDI interface DME, select the
material for the second channel not on the DME external video bus,
but on the AUX bus.
Parameter Adjustment
No AUX bus selection
Setting values
a)
0 to 48
Setup Relating to Switcher Processor
423