Shaped Video Settings - Sony MVS-8000 User Manual

Applying the Separate Sides effect
1
2

Shaped Video Settings

Switching shaped video on or off
You can select whether or not the following signals are treated as shaped video
(a signal subjected to key processing).
• The input video signal from the switcher, for each of the front and back sides
• The output video signal
Notes
• On the MVE-8000, the shaped video function is not supported. On the MVE-
• When the MKE-8021A is installed in the MVE-8000A to provide an SDI
• When using the MVS-8000 dedicated interface, since the input video signal
1
2
138
DME Special Effect Operations
In the DME menu, select VF6 'Input/Output' and HF2 'Video/Key.'
The Video/Key menu appears.
Press [Separate Side], turning it on.
The Separate Sides effect is enabled. If the video and key signals currently
being output to the monitor are the front side, you can select the front
signals. If they are the back side, you can select the back signals. Video and
key signals are selected with the cross-point control blocks of each M/E
bank or the PGM/PST bank.
of an image
8000A, the shaped video function is valid only when the MKE-8021A is
installed to provide an SDI interface.
interface, turning the shaped video function off enables both "Ext Key" and
"Lum Key" in each of the <Front Key> and <Back Key> groups.
to the first channel is always set to the key processed signal on the switcher,
the shaped video setting is always on. For the second and third channel
signals, this may also be turned off.
In the DME menu, select VF6 'Input/Output' and HF2 'Video/Key.'
The Video/Key menu appears.
In the <Shaped Video> group, press each of the following buttons to
switch it on or off.