Sony MVS-8000 User Manual page 269

2
3
Saving a snapshot
1
2
3
4
5
Changing the bank
Change the combination shown on the memory recall buttons (the bank).
1
2
Applying attributes
To apply an attribute to the snapshot represented by a lit-green memory recall
button, use the following procedure.
1
2
268
Snapshot Operations in the Menus
As required, change the bank (see page 268).
Press the button for the number or name you want to recall.
This recalls the snapshot, and the button you pressed lights green.
Display the Misc >Snapshot menu.
Set the state you want to save as a snapshot.
Press [Store].
The button lights amber.
As required, change the bank (see page 268).
Press the button for the number or name you want to save.
This saves the snapshot, and the button goes off.
Press [Bank Sel].
Select the bank in the numeric keypad window.
For example, to show the numbers or names corresponding to registers 11
to 20, select "1" in the numeric keypad window.
To apply the cross-point hold attribute, in the <Attribute Xpt Hold> group
select the appropriate bus.
Note
A setting in the Setup menu determines whether key disable is applied to
cross-point hold or not. For details, see "Setting the operation mode of the
key bus [XPT HOLD] button" (page 409).
Select the following attributes in the <Attribute> group as required.