Sony MVS-8000 User Manual page 415

6
7
To set the delay value
1
2
Making a setting for linking two M/E banks
You can link any two M/E banks for some operations by using the Switcher
>Link >M/E Link menu.
The operations for which you can link two M/E banks are as follows.
• Transition execution (auto transition, cut, and fader lever operation)
• Next transition selection
• Transition type selection
414
Setup Relating to Switcher Processor
The selected video or button name is reflected in the status area.
To clear a video/button name link
Make the selection to which the setting applies, then in the <Video/
Button> group press [Clear].
To select for each bus whether the GPI link setting is enabled or disabled,
use any of the following methods to select the bus to which the setting
applies.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video cursor.
• Turn the knob.
Knob Parameter
4 Bus
In the <Bus> group, select any of the following.
Enable: Enable the GPI link setting for the selected bus.
Disable: Disable the GPI link setting for the selected bus.
All Enable: Enable the GPI link setting for all buses.
In the Switcher >Link >GPI Link Adjust menu, turn the knobs to select the
output port for which you want to set the delay value, and the
corresponding delay value.
Knob Parameter
1 GPI Port
5 Delay
Press [Delay Set].
This confirms the delay value, which is reflected in the status area.
Adjustment
Bus selection
Adjustment
GPI output port for the
setting
Delay value for the output
port
Setting values
1 to 114
Setting values
1 to 8
0 to 300 (fields)