Tadiran Telecom Emerald ICE Installation & Maintenance Manual page 75

3-18
Emerald ICE Installation, Programming & Maintenance Manual
5. Power up the KSU again.
After KSU1 is powered on, the heartbeat LED on the 610+2 Board will begin
flashing 1-2 seconds later. If using 2 KSU's, KSU2 should be powered on
before the heartbeat LED inside KSU1 begins to flash.
If kSU1 is powered on and KSU2 is not while cabling is connected between
the two cabinets, system malfunctions will occur.
6. Verify that the telephones have been initialized. A date/time display will
be visible on the Deluxe Telephones. For a Standard telephone, a dial tone
will be heard.
7. Enter the RMP programming mode and select RP, Remote Control, and
perform a Software Cold Start. It should be approximately 30 seconds
before a display is visible on the Deluxe Telephones or a Dial Tone is
heard on a Standard Telephone.
8. When a display is visible on the Deluxe Telephones or a Dial Tone is heard
on a Standard Telephone, power down the KSU, wait 15 seconds, and then
power up the KSU again.