Tadiran Telecom Emerald ICE Installation & Maintenance Manual page 332

RMP Programming
1. Access the RMP using the procedures described in Section 3.3.
2. Select RP, C.O. Line Application, Trunk Route Settings from the toolbar to
display the following window.
3. Using the drop‐down list in the CO Route: field, select a CO Route to
program.
4. Using the drop‐down lists in the Alt. Route 1: and Alt. Route 2: fields,
select alternate route numbers as necessary. A Trunk Route can be assigned
an Alternate Trunk Route for use if all trunks in this route are busy when a
user places a call. This selection programs the number of the Trunk Route
that shouuld be used of this trunk route is busy. Available selections are
00‐08.
5. Using the drop‐down lists in the Delete Digits fields for Alt. Route 1: and
Alt. Route 2:. select leading digits to be deleted to modify the number
dialed for the appropriate digits necessary to place this call on a trunk in
the Alternate Trunk Route. E.g. If the local (1FB) trunks in the selected
trunk route are all busy when a call is placed that required the digit 1 as
the first dialed digit, you might allow this call to overflow to the VoIP
trunk route where 1 is not needed. In this case enter 1 in this data item.
Available selections are 00‐08.
1 indicates that ONE digit - starting with the first digit should be deleted. If "2"
were entered into this data item, the first two digits of those the user dialed
would be deleted/removed.
Emerald ICE Installation, Programming & Maintenance Manual
11-3