Meet Me Conference - Tadiran Telecom Emerald ICE Installation & Maintenance Manual

Meet Me Conference

7.10
Description
Meet Me Conference is used join telephone connections together. It simplifies the
setup process by assigning designated system resources as conference destinations.
The result is eight separate conference locations that are joined by dialing the
location number. Callers can easily be transferred to these locations. Users may
simply dial the location number. Outside parties can join the conference via the
automated attendant simply by dialing the location number at the auto attendant
greeting.
A programmable Conference Tone may be enabled or disabled so that entry into a
conference is indicated with an alert tone or entered into without an alert tone.
It is highly recommended that all CO lines be set at the factory default for Call
Abandon (Y) to optimize Meet Me Conference functionality.
When Call Abandon is set to N for any CO line, you must set the Meet Me
Conference Talk Time to some value other than 0. This is the only facility that will
allow the CO line to be disconnected if Call Abandon is No.
Up to four simultaneous connections may join any one conference.
Up to eight simultaneous conferences may be established at any one time.
Default Settings:
Call Handling – Meet Me Conference Talk Time is set at 0 (unlimited). (Range is:
0‐120 minutes, in 10‐minute increments.)
Call Handling – Conference Tone is set to Y (Yes). (Range is: Y/N.)
Call Handling – CO Line Conference = 3 Lines. (Range is None/2/3.)
7-33
Emerald ICE Installation, Programming & Maintenance Manual