Flash - Co Line - Tadiran Telecom Emerald ICE Installation & Maintenance Manual

7.15
7-50
Emerald ICE Installation, Programming & Maintenance Manual
Flash – CO Line
Description
Flash – CO Line is a programmed setting that will determine what flash timing will
be presented to the telephone company central office when the user issues a
Hook‐Flash command while connected to a CO Line. This feature is a requirement
when the Emerald ICE is installed "behind" Centrex® or a PBX system. In these
two cases, the Flash feature code should be programmed onto a Feature/DSS
Button for easy access.
If Call Waiting service is provided you can use the Flash feature to answer a
second incoming call while connected to another outside party.
The Flash code may be stored in any speed dial location.
The Flash code may be stored in the Last Number Redial buffer. When you
activate redial, a Deluxe Telephone display will show a " / " to indicate the Flash
code.
The Flash time is programmable from 100ms to 1500ms in increments of 100ms
(1/10th of a second).
At a Deluxe Telephone, when the flash code is dialed CO Flash will be
displayed temporarily.
Single line extensions must generate a hook‐flash on the analog port and then dial
3
/ to generate a hook‐flash on a CO Line.
Default Settings:
CO Flash Time is set to 0.8 seconds. (Range is: 0.1 – 3.0 seconds.)
Deluxe Telephone Programming
1. Access the Deluxe Telephone Programming Features as described in Section
3.2.
2. Enter 03-02 , then press the softkey beneath save . This advances to CO
FLASH programming screen.
3. Press the softkey beneath chg to select the CO Line hook‐flash timing
displays. A CO Flash Time value determines what flash timing will be
presented to the telephone company central office when the user issues a
Hook‐Flash command while connected to a CO Line. Available selections
are from 100-500 in increments of 100 milliseconds.