Enabling Direct Pass-Through Of Hdmi, 3G, And Displayport Input Signals; Disabling Secondary Dvi Receivers; Informing The Source Of Signal Preferences; Adjusting Laser Power - Christie Crimson Series User Manual

Enabling direct pass-through of HDMI, 3G, and
DisplayPort input signals
Allow the signals from HDMI, 3G, and DisplayPort inputs to pass through another projector.
1. Select MENU > Configuration > Input Settings > Enable Video Loop Out.
2. To enable passing HDMI, 3G, and DisplayPort input signals through to another projector, select
Enter.

Disabling secondary DVI receivers

In some cases when using single-link DVI signals, the unused secondary receivers disrupt the signal
detection logic. Disable the secondary receivers if occasional screen flashes are seen while the
projector attempts to re-synchronize to the incoming video.
1. Select MENU > Configuration > Input Settings > Disable Secondary DVI Receiver on
DDIC.
Issuing the (DDD 1) serial command also disables the secondary receivers.
2. To disable the secondary receivers, select Enter.

Informing the source of signal preferences

Configure Crimson Series to automatically inform the video source of the preferred signal formats.
1. If you need a specific frame rate, from the display panel, select MENU > Configuration >
Input Settings > EDID Timing.
2. Select the required EDID timing and select Enter.
60 Hz is the default EDID timing.

Adjusting laser power

Change the power of the laser.
1. Select MENU > Configuration > Light Combiner > Maser Laser Power.
2. Select Enter.
3. To adjust the laser power, use the slider.
4. To confirm your selection, select Enter.

Adjusting the mix of red, blue, and green laser

Adjust the mix of the red, blue, and green lasers.
1. Select MENU > Configuration > Light Combiner.
2. Adjust the value of the laser color you selected by using more or less of it in relation to the
other two colors.
Crimson Series User Guide
020-102649-07 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring system settings
41