Change Lamp - Submenu; Lamp History; Input Switching And Pip Menu; Main Input - Christie J Series User Manual

3.10.6Change Lamp - Submenu

Initiates the lamp change process for the selected lamp and allows the serial number of the new lamp to be
entered. Lamp serial numbers are used for keeping statistics on each lamp used in each lamp position. Entering
of serial numbers is optional, but is recommended.
When using this function, the statistics from the previous lamp are archived, and starts statistics tracking for
the new lamp. If this function is not used, statistics are accumulated (combined) for both the new and old
lamps.

3.10.7Lamp History

Displays the serial number and the number of hours logged for each lamp (currently and previously) installed
in the projector. The top-most entry is always the most recent/current lamp.

3.11 Input Switching and PIP Menu

Use the Input Switching and PIP menu to
enable and define how you want to use PIP.
NOTE: To control the primary image, access
all picture controls through the Main menu. To
control the secondary (PIP) image, access
picture controls through the Input Switching
and Picture-in-Picture menu.

3.11.1Main Input

From the list of active inputs, select one to be used as the primary or main image.

3.11.2PIP Input

From the list of active inputs, select one to be used as the secondary or PIP.

3.11.3Swap Main and PIP Inputs

Toggle the current PIP relationship so that the primary (main) image becomes secondary (PIP), and the
secondary image becomes primary. Swapping is available only when PIP is enabled.
NOTE: You may experience a slight delay when swapping the Primary and Secondary images.

3.11.4PIP Enable

Short cut: Press PIP on the remote if menu not present.
Toggle between displaying two sources at once (Main
and PIP images) and the primary or main source only.
This check box turns the secondary source on and off.

3.11.5PIP Windows Options - Submenu

• Pip Position Presets: Choose a preset location and size of the PIP window. While in split screen mode,
several channel controls that resize image will be disabled. These controls are size, H-Position and V-
Position.
J Series 2.0, 2.4 and 3.0 kW User Manual
020-100707-03 Rev. 1 (02-2014)
Input Switching & PIP
1. Main Input
2. PIP Input
3. Swap Main and PIP Inputs
4. PIP Enable
5. PIP Window Options
6.
PIP Size & Position
7. PIP Image Settings
8.

Fade Time

9.

Frame Locking

10. Auto Input Searching
11.

HDMI Output Loop Source

12.

Standby Active Loop-Through

Primary Image
Adjust through
Main menu
navigation.
Section 3: Operation
Twin HDMI Input Card, Slot 4 Input 1
Twin HDMI Input Card, Slot 4 Input 1
Off
0.20
Frame Lock
Main/Secondary Loop
Secondary
(PIP) Image
Adjust through
PIP menu.
3-51