Configuration - Adjusting System Parameters And Advanced Controls - Christie M-Series User Manual

3.8

Configuration - Adjusting System Parameters and Advanced Controls

Use the Configuration menu to define general operating
parameters and communications with other projectors and
equipment, and to access other advanced processing and
image adjustments affecting overall performance. The
Configuration menu provides access to diagnostics,
calibration tools and the Service submenu (password-
protected).
The first six options in the Configuration menu are explained
below:
• LANGUAGE:
Choose the available language to use in the projector's menus.
The change will take effect immediately.
Output Options - Submenu
• SCREEN IMAGE ORIENTATION:
Select the on screen image orientation from Front, Rear, Front Inverted, and Rear Inverted.
• OUPUT RESOLUTION:
Sets the output pixel resolution; default is the native resolution of the projector.
• FRAME LOCKING:
Select how the projector controls the output frame timing based on the input signal. When set to Framelock,
output image frames are locked to the input if possible. When Locked, the output is always locked to the
primary input, never the PIP image. Free Run sets the output to close to 60Hz for all sources. NOTE: When
switching to a new input with framelocking enabled, the image will appear black for a short duration while the
system locks onto the new input.
• FRAME DELAY:
This control delays the output signal timing relative to the input signal timing by a fraction of a frame, and up
to several frames. The minimum latency can vary based on the amount of scaling applied to the image. When
using keystone or warping, an additional latency is required, depending on the amount of warp. The control is
only available when the input signal is frame locked. In free run mode, or in cases where the signal cannot be
frame locked, the minimum latency defined by the scaling and keystone/warp is applied to the signal.
• FREE RUN FREQUENCY:
This control sets the output video vertical frequency.
Lens Settings - Submenu
• INTELLIGENT LENS SYSTEM:
Check this box to enable the Intelligent Lens System (ILS). When enabled, the lens position (horizontal,
vertical, focus, and zoom offsets) are stored per channel. If you change channels, the lens position will change
as the new signal is being displayed.When ILS is not enabled, the lens is controlled independently of channels
or input signals.
M-Series User Manual
020-100009-02 Rev. 1 (04-2009)
Section 3: Operation
F 3-31 - C
IGURE ONFIGURATION
M
ENU
3-31