Configuration - Adjusting System Parameters And Advanced Controls; Language; Output Options - Submenu - Christie J Series User Manual

Section 3: Operation
3.8

Configuration - Adjusting System Parameters and Advanced Controls

Use the Configuration menu to define general operating parameters and communications with other
projectors and equipment, and to access other advanced processing and image adjustments affecting overall
performance. The Configuration menu provides access to diagnostics, calibration tools and the Service
submenu (password-protected).

3.8.1 LANGUAGE

select the available language to use in the projector menu. The change will take effect immediately.

3.8.2 OUTPUT OPTIONS - Submenu

• SCREEN IMAGE ORIENTATION
Select the on screen image orientation from Front, Rear, Front Inverted, and Rear Inverted.
• FRAME LOCKING
Select how the projector controls the output frame timing based on the input signal. When set to Framelock,
output image frames are locked to the input if possible. When Locked, the output is always locked to the
primary input, never the PIP/Secondary image. Free Run sets the output to close to 60Hz for all sources.
NOTE: When switching to a new input with framelocking enabled, the image will appear black for a short
duration while the system locks onto the new input.
• SET FRAME DELAY
This control delays the output signal timing relative to the input signal timing by a fraction of a frame, and up
to several frames. The minimum latency can vary based on the amount of scaling applied to the image. When
using keystone or warping, an additional latency is required, depending on the amount of warp. The control is
only available when the input signal is frame locked. In free run mode, or in cases where the signal cannot be
frame locked, the minimum latency defined by the scaling and keystone/warp is applied to the signal.
• ACTUAL FRAME DELAY
Dynamically calculated by the software as the achievable range being smaller than the set range. The image
parameters include, image shift, scaling, warp/keystone applied and format. The menu displays both the user
3-32
Figure 3-31 Configuration Menu
J Series 1000W and 1200W User Manual
020-100706-02 Rev. 1 (03-2014)