Configuring Light Settings; Setting Light Source Mode - Christie HS 2K Series User Manual

Configuring light
settings
Learn how to configure the light settings.

Setting light source mode

Set up light source mode depending the environment.
1. Select Menu > Light Source > Light Source Mode.
2. Select appropriate light source mode:
• Constant Power—Enable Constant Power to set the projector brightness to a specific
level controlled by the laser diode power. See
further details of setting the laser diode power.
• Constant Intensity—After enabling Constant Power, select Constant Intensity to
maintain current constant brightness and color settings. This function can remain at
current setting for longer period of time than Constant Power mode and is used for long-
term projecting or blending.
• ECO 1 (80%)—Set the projector to 80% constant brightness and color settings.
• ECO 2 (50%)—Set the projector to 50% constant brightness and color settings.
3. Select ENTER.
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
• Perform light sensor calibration before enabling Constant Intensity.
• When Constant Intensity is enabled, Dynamic Black and Real Black functions are
automatically disabled.
• When Picture Settings is changed under Constant Intensity, the light source mode
automatically changes back to Constant Power.
Adjusting the light power on page 66 for
65