Mode
IMB powered in Standby
Turning on or off the projector
Turn on the projector to display content or turn off the projector to conserve energy or service the
projector.
1. To operate the projector, make sure the circuit breakers are in the ON position.
If servicing the projector or removing the protective covers, make sure the MAIN and UPS
circuit breakers are in the OFF position.
2. In the right toolbar, select and hold Power.
If the light source is on when turning off the projector, the light source automatically enters a
ten-minute cool-down period.
Logging into the projector
Log into the projector to access projector menus.
1. Select Login.
2. In the User list, select a username.
3. Enter your password.
4. Select Login.
Turning on or off the light source
Turn on the light source to display content or view test patterns. Turn off the light to extend the life of
the light source.
•
To turn on or off the light source, in the right toolbar, select and hold Light.
If turning on the light source when the projector power is off, power is turned on automatically.
Allow the projector to cool down for 10 minutes after turning it off.
Activating marriage
After selecting the Integrated Media Block (IMB) type, you must install the IMB and complete marriage
to display secure content and to comply with the Digital Cinema Initiatives (DCI) specification. You
cannot complete marriage remotely.
For more information on marriage, refer to CP2309-RGB User Guide (P/N: 020-103081-XX).
You cannot complete marriage remotely because you must select the Marriage button on the input
panel during the marriage process.
CP2309-RGB Installation and Setup Guide
020-103078-04 Rev. 1 (11-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
• Turns on the IMB
• Increases the air flow inside the projector to cool the card cage electronics
Installing and setting up
25