Table of Contents
Advertisement
Turning on or off the projector
Turn on the projector to display content or turn off the projector to conserve energy or service the
projector.
1. To operate the projector, make sure the circuit breakers are in the ON position.
If servicing the projector or removing the protective covers, make sure the MAIN and UPS
circuit breakers are in the OFF position.
2. In the right toolbar, select and hold Power.
If the light source is on when turning off the projector, the light source automatically enters a
ten-minute cool-down period.
Logging into the projector
Log into the projector to access projector menus.
1. Select Login.
2. In the User list, select a user name.
3. Enter your password.
4. Select Login.
Turning on or off the light source
Turn on the light source to display content or view test patterns. Turn off the light to extend the life of
the light source.
•
To turn on or off the light source, in the right toolbar, select and hold Light.
Activating marriage
After selecting the Integrated Media Block (IMB) type, you must install the IMB and complete marriage
to display secure content and to comply with the Digital Cinema Initiatives (DCI) specification. You
cannot complete marriage remotely.
For more information on marriage, refer to CineLife+ User Guide (P/N: 020-103073-XX).
You cannot complete marriage remotely because you must select the Marriage button on the input
panel during the marriage process.
1. In the left navigation menu, select Service Setup > Marriage Setup.
2. Select Start and complete the Marriage Setup wizard.
3. Select Finish.
4. Verify the marriage ring is installed correctly and an anti-tamper alarm does not appear on the
touch panel.
CP4415-RGB and CP4420-RGB Gen2 Installation and Setup Guide
020-103773-01 Rev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
30
Advertisement
Table of Contents
