Setting Up The Network Environment; Connecting A Single Projector To A Computer; Connecting Multiple Projectors To A Computer; Configuring The Network - Christie H Series User Manual

Warping and blending

Hide thumbs Also See for H Series:

Table of Contents

Setting up the network environment

Learn how to connect projectors to a computer, and configure the network.

Follow these steps to connect a single projector to a computer.

1. Connect the Ethernet cable to the Ethernet port on the computer.

2. Connect the other end of the Ethernet cable to the Ethernet port on the projector.

3. To have the projector and the computer on the same network and subnet, configure the

network.

Learn how to connect multiple projectors to a computer.

1. Connect Ethernet cables to the Ethernet port on each of the projectors.

2. Connect the other end of the Ethernet cables to a network hub.

3. Connect an Ethernet cable between the network hub and the computer.

4. To have the projector and the computer on the same network and subnet, configure the

network.

To have the projector and the computer on the same network and subnet, configure the network.

1. Open the Control Panel and select Network and Sharing Center.

2. Select Local Area Connection > Properties.

3. Select Internet Protocol Version 4 (TCP/IPv4) > Properties.

4. On the General tab, select Use the following IP address.

5. Enter the IP address and Subnet mask for the network.

Make sure the network IP address does not conflict with any projector IP addresses.

The Subnet mask should be set to the same subnet as the projector.

6. Select OK.

7. To close the Local Area Connection Properties, select OK.

8. To close the Local Area Connection Status, select Close.

H Series, HS Series, GS Series and Inspire Series User Guide–Warping and Blending

020-000807-03 Rev. 1 (01-2024)

If printed, please recycle this document after use.

Installing the Blending and Warping application

Table of Contents