Resetting Edge Blending; Blending Black Levels For Multiple Projectors; Enabling Black Level Blending; Adjusting The Black Level Blends - Christie Crimson Series User Manual

4. To edit blending adjustments, select Edge Blend Widths.
5. From the Basic Blending dialog, select a side to blend.
6. To make the blending adjustments, use the arrow keys to change either the vertical and
horizontal values as appropriate.
7. To accept the selection, select Enter.
8. Repeat steps 4 to 6 to blend the remaining sides.
9. When all adjustments are made, use the arrow keys to highlight Apply and select Enter.
10. Repeat steps 2 to 9 for the remaining projectors.
11. To turn off basic edge blending, from MENU > Configuration > Edge Blending, select Off.

Resetting edge blending

Reset the edge blending to revert any edge blends.
1. Select MENU > Configuration > Edge Blending.
2. Select Reset Edge Blends.
3. At the confirmation prompt, select Reset.

Blending black levels for multiple projectors

Use black level blending to modify the brightness of non-blended regions to match the elevated
brightness levels of the blended regions.
You can adjust the black level intensity of multiple adjacent projected images to create one large
seamless display.

Enabling black level blending

Enable black level blending to eliminate the differences between black levels when edge blending
multiple projectors.
1. Select MENU > Configuration > Black Level Blending > Black Level Blending Mode.
2. Select Basic.
To disable black level blending, select MENU > Configuration > Black Level Blending >
Black Level Blending Mode > Off.

Adjusting the black level blends

Control how the edges of adjacent images are overlapped to create a seamless image.
1. Start with a minimum of two projectors and display the full black field test pattern from each
projector.
2. On one projector, select MENU > Configuration > Black Level Blending > Black Level
Blend Widths.
3. Set the black level blend widths of the top, bottom, left, or right edges (depending on which
edge of the projector you are working with to black level blend).
• To use the widths set by the edge blend, select Use Edge Blend Width Values.
Crimson Series User Guide
020-102649-07 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
33