Connecting The Projector Head To Ac Power; Setting Up The Laser Illumination Source - Christie Mirage SST Installation And Setup Manual

Connecting the projector head to AC power

Connect the projector head to the AC power.
1. On the projector head, ensure the AC breaker/switch is in the off position.
2. Connect AC power to the AC inlet on the projector.
For electrical rating information, refer to the license label on the projector.
3. To ensure the AC power cord does not fall out, pull out the safety retainer clip from the holder
and clip over the power cord connector.
To unplug, raise up the retainer clip and pull out the cord.

Setting up the laser illumination source

Follow these steps to set up the laser illumination source.
1. Position the laser illumination source on level ground and make sure the fiber optic cable is
routed in a way to avoid any damage.
Mirage SST Installation and Setup Guide
020-102956-08 Rev. 1 (09-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
28