Configuring input
settings
Learn how to configure the input source and picture in picture (PIP)/picture by picture (PBP)
settings.
Setting main input source
Set up the active input to be used as the main image.
1. Select Menu > Input Switching & PIP > Main Input.
2. To select the active input, select ENTER.
Setting second input source
Select an active input to be used as the picture in picture (PIP)/picture by picture (PBP). Before
setting the second input source, make sure to enable PIP/PBP otherwise this item is disabled.
1. Select Menu > Input Switching & PIP > PIP/PBP Input.
2. To select another active input, select ENTER.
Enabling second input source
To activate the picture in picture (PIP)/picture by picture (PBP) setting, switch on this function.
1. Select Menu > Input Switching & PIP > PIP/PBP Enable.
2. To swap, select ENTER.
To update the PIP/PBP mode, run the Input Switching & PIP > Auto Image Resync function.
Auto Image Resync synchronizes the main input and the sub input sources simultaneously.
HS Series 2K User Manual
020-002040-01 Rev. 1 (05-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
69