5.6.12 The Display is "Noisy"
1. Display adjustment at your input source may be required. Adjust pixel tracking, phase and filter. Noise is
particularly common on YPbPr signals from a DVD player.
2. The video input may not be terminated. Ensure the video input is terminated (75 S). If it is the last
connection in a loop-through chain, the video input should be terminated at the last source input only.
3. The input signal and/or signal cables carrying the input signal may be of poor quality.
4. If the distance between the input source device and the projector is greater than 25 feet, signal amplifica-
tion/conditioning may be required.
5. If the source is a VCR or off-air broadcast, detail may be set too high.
5.6.13 There are Random Streaks on the Bottom of the Image
1. If a 24Hz or 25Hz HD-SDI signal, or a 50 Hz SDI digital PAL signal is used, ensure non-cinema
processing is selected. This can be implemented via the Channel: Page 1 menu of the web user interface
by disabling the Cinema checkbox. NOTE: This is password-protected.
CP2000-ZX User Manual
020-100006-05 Rev. 1 (05-2009)
Section 5: Troubleshooting
5-7