Ip Addressing Commands; Ip Address - HP Bc1500 - BladeSystem - Blade PC Reference Manual

ip address

The ip address Interface Configuration (Ethernet, VLAN, port-channel) mode command sets an
IP address. To remove an IP address, use the no form of this command.
Syntax
ip address ip-address {mask | prefix-length}
no ip address [ip-address]
Parameters
■
ip-address —Valid IP address
■
mask — Valid network mask of the IP address.
■
prefix-length — Specifies the number of bits that comprise the IP address prefix. The prefix
length must be preceded by a forward slash (/). (Range: 8-30)
Default Setting
Two interfaces are configured:
■
one for VLAN 1
■
one for VLAN 2, with DHCP set by default
Command Mode
Interface Configuration (Ethernet, VLAN, port-channel) mode
Command Usage
An IP address cannot be configured for a range of interfaces (range context).
Example
The following command configures VLAN 1 with IP address 131.108.1.27 and subnet mask
255.255.255.0.
Console(config)# interface vlan 1
Console(config-if)# ip address 131.108.1.27 255.255.255.0
HP PC Blade Switch CLI Reference Guide

IP Addressing Commands

www.hp.com
11
11-1