Port Security Routed Secure-Address - HP Bc1500 - BladeSystem - Blade PC Reference Manual

port security routed secure-address

The port security routed secure-address Interface Configuration (Ethernet, port-channel) mode
command adds a MAC-layer secure address to a routed port. Use the no form of this command to
delete a MAC address.
Syntax
port security routed secure-address mac-address
no port security routed secure-address mac-address
Parameters
■
mac-address — A valid MAC address.
Default Setting
No addresses are defined.
Command Mode
Interface Configuration (Ethernet, port-channel) mode. Cannot be configured for a range of
interfaces (range context).
Command Usage
The command enables adding secure MAC addresses to a routed port in port security mode. The
command is available when the port is a routed port and in port security mode. The address is
deleted if the port exits the security mode or is not a routed port.
Use this command on interfaces that have an IP address configured, instead of the command
bridge address mac-address {ethernet interface port-channel port-channel-number}
[secure]
.
Example
The following command adds the MAC-layer address 66:66:66:66:66:66 to port 1/e1.
Console(config)# interface ethernet 1/e1
Console(config-if)# port security routed secure-address 66:66:66:66:66:66
HP PC Blade Switch CLI Reference Guide www.hp.com
Address Table Commands
5-13