HP Bc1500 - BladeSystem - Blade PC Reference Manual page 59
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
IP Protocol
Ipv6 Protocol
Routing Header for IPv6
Fragment Header for IPv6
Inter-Domain Routing Protocol
Reservation Protocol
General Routing Encapsulation
Encapsulating Security Payload (50)
Authentication Header
ICMP for IPv6Protocol
EIGRP Routing Protocol
Open Shortest Path Protocol
Protocol Independent Multicast
Layer Two Tunneling Protocol
ISIS over IPv4 Protocol
(any IP protocol)
■
DSCP — Indicates matching the dscp number with the packet DSCP value.
■
ip-precedence — Indicates matching ip-precedence with the packet ip-precedence value.
■
icmp-type — Specifies an ICMP message type for filtering ICMP packets. Enter a value or
one of the following values: echo-reply, destination-unreachable, source-quench,
redirect, alternate-host-address, echo-request, router-advertisement,
router-solicitation, time-exceeded, parameter-problem, timestamp, timestamp-reply,
information-request, information-reply, address-mask-request, address-mask-reply,
traceroute, datagram-conversion-error, mobile-host-redirect, ipv6-where-are-you,
ipv6-i-am-here, mobile-registration-request, mobile-registration-reply,
domain-name-request, domain-name-reply, skip and photuris. (Range: 0-255)
■
icmp-code — Specifies an ICMP message code for filtering ICMP packets. ICMP packets
that are filtered by ICMP message type can also be filtered by the ICMP message code.
(Range: 0-255)
■
igmp-type — IGMP packets can be filtered by IGMP message type. Enter a number or one of
the following values: dvmrp, host-query, host-report, pim or trace, host-report-v2,
host-leave-v2, host-report-v3 (Range: 0-255)
■
destination-port — Specifies the UDP/TCP destination port. (Range: 0-65535)
■
source-port — Specifies the UDP/TCP source port. (Range: 0-65535)
■
list-of-flags — Specifies a list of TCP flags that can be triggered. If a flag is set, it is prefixed
by "+". If a flag is not set, it is prefixed by "-". Possible values: +urg, +ack, +psh, +rst,
+syn, +fin, -urg, -ack, -psh, -rst, -syn and -fin. The flags are concatenated into one string.
For example: +fin-ack.
HP PC Blade Switch CLI Reference Guide
Abbreviated Name
ipv6
ipv6-route
ipv6-frag
idrp
rsvp
gre
esp
ah
ipv6-icmp
eigrp
ospf
pim
l2tp
isis
any
www.hp.com
ACL Commands
Protocol Number
41
43
44
45
46
47
50
51
58
88
89
103
115
124
(25504)
4-3
Advertisement
Table of Contents
