Ethernet Configuration Commands
flowcontrol
The flowcontrol Interface Configuration (Ethernet, port-channel) mode command configures
flow control on a given interface. To disable flow control, use the no form of this command.
Syntax
flowcontrol {auto | on | off}
no flowcontrol
Parameters
■
auto — Indicates auto-negotiation
■
on — Enables flow control.
■
off — Disables flow control.
Default Setting
Flow control is off.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
Negotiation should be enabled for flowcontrol auto.
Example
In the following example, flow control is enabled on port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# flowcontrol on
8-8
www.hp.com
HP PC Blade Switch CLI Reference Guide