Bridge Multicast Forbidden Forward-All - HP Bc1500 - BladeSystem - Blade PC Reference Manual

bridge multicast forbidden forward-all

The bridge multicast forbidden forward-all Interface Configuration (VLAN) mode command
forbids a port to be a forward-all-multicast port. To restore the default configuration, use the no
form of this command.
Syntax
bridge multicast forbidden forward-all {add | remove} {ethernet interface-list | port-channel
port-channel-number-list}
no bridge multicast forbidden forward-all
Parameters
■
add — Forbids forwarding all multicast packets.
■
remove — Does not forbid forwarding all multicast packets.
■
interface-list — Separates nonconsecutive Ethernet ports with a comma and no spaces; a
hyphen is used to designate a range of ports.
■
port-channel-number-list — Separates nonconsecutive port-channels with a comma and no
spaces; a hyphen is used to designate a range of port-channels.
Default Setting
This setting is disabled.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
IGMP snooping dynamically discovers multicast device ports. When a multicast device port is
discovered, all the multicast packets are forwarded to it unconditionally.
This command prevents a port from becoming a multicast device port.
Example
The following command configures the device to forbid all forwarding of Multicast packets to
1/e1 with VLAN 2.
Console(config)# interface vlan 2
Console(config-if)# bridge multicast forbidden forward-all add ethernet 1/e1
HP PC Blade Switch CLI Reference Guide www.hp.com
Address Table Commands
5-7