Radius Commands; Radius-Server Host - HP Bc1500 - BladeSystem - Blade PC Reference Manual

radius-server host

The radius-server host Global Configuration mode command specifies a RADIUS server host.
To delete the specified RADIUS host, use the no form of this command.
Syntax
radius-server host {ip-address | hostname} [auth-port auth-port-number] [timeout timeout]
[retransmit retries] [deadtime deadtime] [key key-string] [source source] [priority priority]
no radius-server host {ip-address | hostname}
Parameters
■
ip-address — IP address of the RADIUS server host.
■
hostname — Hostname of the RADIUS server host. (Range: 1-158 characters)
■
auth-port-number — Port number for authentication requests. The host is not used for
authentication if the port number is set to 0. (Range: 0-65535)
■
timeout — Specifies the timeout value in seconds. (Range: 1-30)
■
retries — Specifies the retransmit value. (Range: 1-10)
■
deadtime — Length of time in minutes during which a RADIUS server is skipped over by
transaction requests. (Range: 0-2000)
■
key-string — Specifies the authentication and encryption key for all RADIUS
communications between the device and the RADIUS server. This key must match the
RADIUS daemon key used on the RADIUS daemon. To specify an empty string, enter "".
(Range: 0-128 characters)
■
source — Specifies the source IP address to use for communication. 0.0.0.0 is interpreted as
request to use the IP address of the outgoing IP interface.
■
priority — Determines the order in which servers are used, where 0 has the highest priority.
(Range: 0-65535)
■
usage — Specifies the usage type of the server. Can be one of the following values: login,
dot.1x or all. If unspecified, defaults to all.
Default Setting
No RADIUS server host is specified.
The port number for authentication requests is 1812.
The usage type is all.
Command Mode
Global Configuration mode
HP PC Blade Switch CLI Reference Guide

RADIUS Commands

www.hp.com
19
19-1