Default Setting - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
ACL Commands
Default Setting
No IPv4 ACL is defined.
Command Mode
IP-Access List Configuration mode
Command Usage
Use the ip access-list Global Configuration mode command to enable the IP-Access List
Configuration mode.
Before an Access Control Element (ACE) is added to an ACL, all packets are permitted. After an
ACE is added, an implied deny-any-any condition exists at the end of the list and those packets
that do not match the conditions defined in the permit statement are denied.
Example
The following command define a permit statement for an IP ACL.
Console(config)# ip access-list ip-acl1
Console(config-ip-al)# permit rsvp 192.1.1.1 0.0.0.0 any dscp 56
4-4
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
