Sntp Server - HP Bc1500 - BladeSystem - Blade PC Reference Manual

sntp server

The sntp server Global Configuration mode command configures the device to use the Simple
Network Time Protocol (SNTP) to request and accept SNTP traffic from a specified server. To
remove a server from the list of SNTP servers, use the no form of this command.
Syntax
sntp server {ip-address | hostname}[poll] [key keyid]
no sntp server host
Parameters
■
ip-address — IP address of the server.
■
hostname — Hostname of the server. (Range: 1-158 characters)
■
poll — Enable polling.
■
keyid — Authentication key to use when sending packets to this peer.
(Range: 1-4294967295)
Default Setting
No servers are defined.
Command Mode
Global Configuration mode
Command Usage
Up to 8 SNTP servers can be defined.
Use the sntp unicast client enable Global Configuration mode command to enable predefined
unicast clients globally.
To enable polling you should also use the sntp unicast client poll Global Configuration mode
command for global enabling.
Polling time is determined by the sntp client poll timer Global Configuration mode command.
Example
The following command configures the device to accept SNTP traffic from the server on
192.1.1.1.
Console(config)# sntp server 192.1.1.1
HP PC Blade Switch CLI Reference Guide www.hp.com
Clock Commands
6-15