Deny (Ip) - HP Bc1500 - BladeSystem - Blade PC Reference Manual

deny (IP)

The deny IP-Access List Configuration mode command denies traffic if the conditions defined in
the deny statement match.
Syntax
deny [disable-port] {any | protocol} {any | {source source-wildcard}} {any | {destination
destination-wildcard}} [dscp dscp number | ip-precedence ip-precedence]
deny {any | protocol} {any | {source source-wildcard}} {any | {destination
destination-wildcard}} [dscp dscp-number | ip-precedence ip-precedence]
deny-icmp {any | {source source-wildcard}} {any | {destination destination-wildcard}} {any |
icmp-type} {any | icmp-code} [dscp number | ip-precedence number]
deny-igmp {any | {source source-wildcard}} {any | {destination destination-wildcard}} {any
| igmp-type} [dscp number | ip-precedence number]
Parameters
■
disable-port — Specifies that the port should be disabled if the conditions defined match.
■
source — Specifies the IP address or host name from which the packet was sent. Specify any
to indicate IP address 0.0.0.0 and mask 255.255.255.255.
■
source-wildcard — Specifies wildcard bits by placing 1s in bit positions to be ignored.
Specify any to indicate IP address 0.0.0.0 and mask 255.255.255.255.
■
destination — Specifies the IP address or host name to which the packet is being sent.
Specify any to indicate IP address 0.0.0.0 and mask 255.255.255.255.
■
destination-wildcard — Specifies wildcard bits by placing 1s in bit positions to be ignored.
Specify any to indicate IP address 0.0.0.0 and mask 255.255.255.255.
■
protocol — Specifies the abbreviated name or number of an IP protocol.
The following table lists protocols that can be specified:
IP Protocol
Internet Control Message Protocol
Internet Group Management Protocol
IP in IP (encapsulation) Protocol
Transmission Control Protocol
Exterior Gateway Protocol
Interior Gateway Protocol
User Datagram Protocol
Host Monitoring Protocol
Reliable Data Protocol
Inter-Domain Policy Routing Protocol
Ipv6 Protocol
Routing Header for IPv6
Fragment Header for IPv6
HP PC Blade Switch CLI Reference Guide
Abbreviated Name
icmp
igmp
ipinip
tcp
egp
igp
udp
hmp
rdp
idpr
ipv6
ipv6-route
ipv6-frag
www.hp.com
ACL Commands
Protocol Number
1
2
4
6
8
9
17
20
27
35
41
43
44
4-5