Dot1X Single-Host-Violation - HP Bc1500 - BladeSystem - Blade PC Reference Manual

802.1x Commands

dot1x single-host-violation

The dot1x single-host-violation Interface Configuration mode command configures the action
to be taken, when a station whose MAC address is not the supplicant MAC address, attempts to
access the interface. Use the no form of this command to return to default.
Syntax
dot1x single-host-violation {forward | discard | discard-shutdown} [trap seconds]
no port dot1x single-host-violation
Parameters
■
forward — Forwards frames with source addresses that are not the supplicant address, but
does not learn the source addresses.
■
discard — Discards frames with source addresses that are not the supplicant address.
■
discard-shutdown — Discards frames with source addresses that are not the supplicant
address. The port is also shut down.
■
trap — Indicates that SNMP traps are sent.
■
seconds — Specifies the minimum amount of time in seconds between consecutive traps.
(Range: 1-1000000
Default Setting
Frames with source addresses that are not the supplicant address are discarded.
No traps are sent.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
The command is relevant when multiple hosts is disabled and the user has been successfully
authenticated.
Example
The following command forwards frames with source addresses that are not the supplicant
address and sends consecutive traps at intervals of 100 seconds.
Console(config-if)# dot1x single-host-violation forward trap 100
2-20
)
www.hp.com HP PC Blade Switch CLI Reference Guide