Autobaud - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
autobaud
The autobaud Line Configuration mode command sets the line for automatic baud rate detection
(autobaud). To disable automatic baud rate detection, use the no form of the command.
Syntax
autobaud
no autobaud
Parameters
There are no parameters for this command.
Default Setting
Autobaud is disabled.
Command Mode
Line Configuration (console) mode
Command Usage
This command is available only on the line console.
To start communication using Autobaud, press <Enter> twice. This configuration applies only to
the current session.
Example
The following command enables autobaud.
Console(config)# line console
Console(config-line)# autobaud
HP PC Blade Switch CLI Reference Guide
www.hp.com
Line Commands
13-3
Advertisement
Table of Contents
