802.1x Commands
Advanced Features
dot1x auth-not-req
The dot1x auth-not-req Interface Configuration mode command enables unauthorized devices
access to the VLAN. To disable access to the VLAN, use the no form of this command.
Syntax
dot1x auth-not-req
no dot1x auth-not-req
Parameters
There are no parameters for this command.
Default Configuration
Access is enabled.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
An access port cannot be a member in an unauthenticated VLAN.
The native VLAN of a trunk port cannot be an unauthenticated VLAN.
For a general port, the PVID can be an unauthenticated VLAN (although only tagged packets
would be accepted in the unauthorized state.)
Example
The following command enables access to the VLAN to unauthorized devices.
Console(config-if)# dot1x auth-not-req
2-18
www.hp.com
HP PC Blade Switch CLI Reference Guide