Need Only A Quick Start; Ip Addressing; To Set Up And Install The Switch In Your Network - HP ProCurve 5300xl Series Management Manual

Getting Started

Need Only a Quick Start?

I m p o r t a n t !
1-8
If you need further information on Hewlett-Packard switch technology,
■
visit the HP ProCurve website at:
http://www.hp.com/go/hpprocurve

Need Only a Quick Start?

IP Addressing

If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using VLANs, HP recommends that you use
the Switch Setup screen to quickly configure IP addressing. To do so, do one
of the following:
Enter setup at the CLI Manager level prompt.
■
HPswitch# setup
■ In the Main Menu of the Menu interface, select
8. Run Setup
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.

To Set Up and Install the Switch in Your Network

Use the HP Procurve Installation and Getting Started Guide (shipped with
the switch) for the following:
Notes, cautions, and warnings related to installing and using the switch
■
and its related modules
■ Instructions for physically installing the switch in your network
Quickly assigning an IP address and subnet mask, set a Manager pass-
■
word, and (optionally) configure other basic features.
Interpreting LED behavior.
■
For the latest version of the Installation and Getting Started Guide for your
switch, refer to "Getting Documentation From the Web" on page 1-6.