Port Storm-Control Broadcast Rate - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
Ethernet Configuration Commands
port storm-control broadcast rate
The port storm-control broadcast rate Interface Configuration (Ethernet) mode command
configures the maximum broadcast rate. To return to the default configuration, use the no form of
this command.
Syntax
port storm-control broadcast rate rate
no port storm-control broadcast rate
Parameters
■
rate — Maximum kilobits per second of broadcast and multicast traffic on a port. (Range:
70-100000).
Default Setting
The default storm control broadcast rate is 3500 Kbits/Sec.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
Use the port storm-control broadcast enable Interface Configuration mode command to enable
broadcast storm control.
Example
The following command configures the maximum storm control broadcast rate at 900 Kbits/Sec
on Ethernet port 1/e5 of a device.
Console(config)# interface ethernet 1/e5
Console(config-if)# port storm-control broadcast rate 900
8-22
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
