Switchport General Allowed Vlan - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
VLAN Commands
switchport general allowed vlan
The switchport general allowed vlan Interface Configuration mode command adds or removes
VLANs from a general port.
Syntax
switchport general allowed vlan add vlan-list [tagged | untagged]
switchport general allowed vlan remove vlan-list
Parameters
■
add vlan-list — Specifies the list of VLAN IDs to be added. Separate nonconsecutive VLAN
IDs with a comma and no spaces. A hyphen designates a range of IDs.
■
remove vlan-list — Specifies the list of VLAN IDs to be removed. Separate nonconsecutive
VLAN IDs with a comma and no spaces. A hyphen designates a range of IDs.
■
tagged — Indicates that the port transmits tagged packets for the VLANs.
■
untagged — Indicates that the port transmits untagged packets for the VLANs.
Default Setting
If the port is added to a VLAN without specifying tagged or untagged, the default setting is
tagged.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
This command enables changing the egress rule (e.g., from tagged to untagged) without first
removing the VLAN from the list.
Example
The following commands add VLANs 2, 5, and 6 to the allowed list of Ethernet port 1/e16 .
Console(config)# interface ethernet 1/e16
Console(config-if)# switchport general allowed vlan add 2,5-6 tagged
28-10
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
