Port Storm-Control Include-Multicast (Ic) - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
Ethernet Configuration Commands
port storm-control include-multicast (IC)
The port storm-control include-multicast Interface Configuration (Ethernet) mode command
counts multicast packets in broadcast storm control. To disable counting multicast packets, use
the no form of this command.
Syntax
port storm-control include-multicast [unknown-unicast]
no port storm-control include-multicast
Parameters
■
unknown-unicast — Specifies also counting unknown unicast packets.
Default Setting
Multicast packets are not counted.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
To control multicasts storms, use the port storm-control broadcast enable and port
storm-control broadcast rate commands.
Example
The following command enables counting broadcast and multicast packets on Ethernet port 2/e3.
Console(config)# interface ethernet 2/e3
Console(config-if)# port storm-control include-multicast
8-20
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
