Dot1X Timeout Tx-Period - HP Bc1500 - BladeSystem - Blade PC Reference Manual

802.1x Commands

dot1x timeout tx-period

The dot1x timeout tx-period Interface Configuration mode command sets the number of
seconds that the device waits for a response to an Extensible Authentication Protocol
(EAP)-request/identity frame from the client before resending the request. To return to the
default configuration, use the no form of this command.
Syntax
dot1x timeout tx-period seconds
no dot1x timeout tx-period
Parameters
■
seconds — Specifies the time in seconds that the device waits for a response to an
EAP-request/identity frame from the client before resending the request.
(Range: 1-65535 seconds)
Default Configuration
Timeout period is 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
The default value of this command should be changed only to adjust for unusual circumstances,
such as unreliable links or specific behavioral problems with certain clients and authentication
servers.
Example
The following command sets the number of seconds that the device waits for a response to an
EAP-request/identity frame, to 3600 seconds.
Console(config)# interface ethernet 1/e16
Console(config-if)# dot1x timeout tx-period 3600
2-8 www.hp.com HP PC Blade Switch CLI Reference Guide